Tektronix MTG100, MTG300 Portable Generator User Manual


 
Removal and Installation Procedures
MTG100 & MTG300 MPEG Generator Service Manual
6Ć17
Access Procedure
When you have identified the module to be removed for service, read General
Instructions found on page 6-10. Then use the flowchart in Figure 6-6 to
determine which procedures to use for removing the module. The removal
procedures end with installation instructions.
Is
the module
in Figure
6Ć2?
Yes
No
Locate the module to
be removed in
Figure 6Ć2 to 6Ć5.
Procedures for External Modules
Line cord p.6Ć18
Cabinet p.6Ć18
Front panel unit p.6Ć21
Front panel assembly p.6Ć22
Do the procedures, Line
Cord and Cabinet on
page 6Ć18.
Is
the module
in Figure
6Ć4?
Yes
No
Procedures for Board Modules and
CPU unit
A10 Main board p.6Ć37
A40 MISC (Power distribution &
Interface) board p.6Ć39
CPU unit p.6Ć41
Is
the module
in Figure
6Ć3?
Yes
Procedures for Internal Modules
Fan p.6Ć25
Floppy disk drive p.6Ć26
Data hard disk drive p.6Ć28
System hard disk drive p.6Ć30
Display module p.6Ć32
Power supply unit p.6Ć34
Procedures for Rear Panel Modules
BNC cable assembly p.6Ć44
BNC connector p.6Ć45
ECL/TTL/LVDS OUT
connector p.6Ć45
ECL CONTROL connector p.6Ć46
No
Figure 6Ć6: Guide to removal procedures