Filter
Top Products
MTG100 & MTG300 MPEG Generator Service Manual
6Ć9
Removal and Installation Procedures
This subsection contains procedures for removal and installation of all mechani-
cal and electrical modules. Any electrical or mechanical module, assembly, or
part listed in Section 10 of this manual is a module.
Preparation
WARNING. Before performing this or any other procedure in this manual, read
the Safety Summary found at the beginning of this manual. Also, to prevent
possible injury to service personnel or damage to the MPEG generator’s
components, read Installation in Section 2, and Preventing ESD in this section.
This subsection contains the following items:
H Preparatory information that you need to properly perform the procedures
that follow.
H List of tools required to remove and disassemble all modules.
H Four module locator diagrams for finding the External modules (see Figure
6-2), Internal modules (see Figure 6-3), Board modules and CPU unit (see
Figure 6-4), and Rear panel modules (see Figure 6-5) in the MPEG
generator.
H Procedures for removal and reinstallation of the electrical and mechanical
modules.
H A disassembly procedure for removal of all the major modules from the
MPEG generator at one time and for reassembly of those modules into the
MPEG generator. Such a complete disassembly is normally only done when
completely cleaning the MPEG generator. (Instructions for doing the actual
cleaning are found under Inspection and Cleaning at the beginning of this
section.)
H Module disassembly procedures.
WARNING. Before performing any procedure in this subsection, disconnect the
power cord from the line voltage source. Failure to do so could cause serious
injury or death.