Filter
Top Products
Removal and Installation Procedures
6Ć18
MTG100 & MTG300 MPEG Generator Service Manual
Procedures for External Modules
Do the Access Procedure (page 6-17) before doing any procedure in this group.
This group contains the following procedures:
H Line Cord
H Cabinet
H Front-Panel Unit
H Front-Panel Assembly
1. Assemble equipment and locate modules to be removed: You need no
equipment. Locate the line cord in the location diagram External Modules,
Figure 6-2, page 6-13.
2. Orient the instrument: Set the MPEG generator so its bottom is down on the
work surface and its rear is facing you.
3. Remove line cord: Find the line cord on the rear panel. Grasp the plug and
pull the line cord and clamp away to complete the removal. Reverse
procedure to reinstall.
1. Assemble equipment and locate modules to be removed:
a. You need a screwdriver with a size #2 Phillips tips (Items 1 and 3).
b. Locate the modules to be removed in the locator diagram External
modules, Figure 6-2, page 6-13.
2. Orient instrument: Set the MPEG generator so its right is down on the work
surface and its rear is facing you.
3. Disconnect line cord: Unplug the line cord from its receptacle at the rear
panel.
4. Remove cabinet:
a. Using a screwdriver with a size #2 Phillips tip, remove the four screws
securing the front of the cabinet to the MPEG generator.
b. Using a screwdriver with a size #2 Phillips tip, remove the six screws
securing the rear of the cabinet to the MPEG generator.
c. Set the MPEG generator so its bottom is down on the work surface and
its front is facing you.
Line Cord
Cabinet