Troubleshooting
6Ć52
MTG100 & MTG300 MPEG Generator Service Manual
When you execute the Simple Scandisk or Normal Scandisk command, the test
result is saved as a file (/ide0/scandisk.res). Using this test result, you can check
the number of clusters where errors were detected and clusters where errors were
recovered. This file is not deleted when the hard disks are formatted.
The scandisk output file uses the following form:
1999/12/16 10:10:35,SIMPLE,T:11111111,R1:22222222,
E1:33333333,F1:44444444,R2:55555555,E2:66666666,F2:77777777
H 1999/12/16 10:10:35 : Shows the time when the scandisk operation was
completed.
H SIMPLE or NORMAL : Shows the type of the executed scandisk com-
mand.
H T:11111111 : Shows the number of clusters for checking.
H R1:22222222 : Shows the number of clusters from which errors were
recovered on disk 1.
H E1:33333333 : Shows the number of clusters in which errors were detected
on disk 1.
H F1:44444444 : Shows the number of clusters from which errors were not
recovered on disk 1.
H R2:55555555 : Shows the number of clusters from which errors were
recovered on disk 2.
H E2:66666666 : Shows the number of clusters in which errors were detected
on disk 2.
H F2:77777777 : Shows the number of clusters from which errors were not
recovered on disk 2.
Scandisk Output File