Filter
Top Products
Specifications
MTG100 & MTG300 MPEG Generator Service Manual
1Ć11
Certifications and Compliances
This subsection lists the national and international standards to which the MPEG
generator complies.
Table 1Ć6: Certifications and compliances
Category Standards or description
EC Declaration of Conformity -
EMC
Meets the intent of Directive 89/336/EEC for Electromagnetic Compatibility. Compliance was
demonstrated to the following specifications as listed in the Official Journal of the European
Communities:
EMC Directive 89/336/EEC:
EN 61000Ć3Ć2 AC Power Line Harmonic Emissions
EN 61000Ć3Ć3 Voltage Fluctuations and Flicker Emissions
EN 61326Ć1 EMC requirement for Class A electrical equipment for
measurement, control and laboratory use.
IEC 61000Ć4Ć2 Electrostatic Discharge Immunity (Performance Criterion B)
IEC 61000Ć4Ć3 RF Electromagnetic Field Immunity (Performance Criterion A)
IEC 61000Ć4Ć4 Electrical Fast Transient / Burst Immunity (Performance Criterion B)
IEC 61000Ć4Ć5 Power Line Surge Immunity (Performance Criterion B)
IEC 61000Ć4Ć6 Conducted RF Immunity (Performance Criterion A)
IEC 61000Ć4Ć8 Power Frequency Electromagnetic Field Immunity
(Performance Criterion A)
IEC 61000Ć4Ć11 Voltage Dips and Interruptions Immunity (Performance Criterion B)
Australia/New Zealand Declaration
of Conformity - EMC
Complies with EMC provision of Radio Communications Act per the following standard(s):
AS/NZS 2064.1/2 Industrial, Scientific, and Medical Equipment: 1992
FCC Compliance Emissions comply with FCC Code of Federal Regulations 47, Part 15, Subpart B, Class A Limits.
Safety Complies with the following safety standards/regulations:
UL 3111Ć1, First Edition
1
Standard for electrical measuring and test equipment.
CAN/CSA C22.2 No.1010.1Ć92
1
Safety requirements for electrical equipment for
measurement, control, and laboratory use.
IEC 61010Ć1/A2:1995
1
Safety requirements for electrical equipment for
measurement, control,and laboratory use.
Low Voltage Directive 73/23/EEC: Amended by 93/68/EEC:
EN 61010Ć1/A2 Safety requirements for electrical equipment for
measurement, control,and laboratory use.
1
UL3111Ć1 First Edition, CSA C22.2 No.1010.1Ć92, and IEC61010Ć1/A2:1995 Safety Certification Compliance Altitude
(maximum operating): 2000 meters