Tektronix MTG100, MTG300 Portable Generator User Manual


 
Removal and Installation Procedures
MTG100 & MTG300 MPEG Generator Service Manual
6Ć11
Equipment Required. Most modules in this MPEG generator can be removed with
a screwdriver handle mounted with a size #2, Phillips tip. Use this tool whenever
a procedure step instructs you to remove or install a screw unless a different size
screwdriver is specified in that step. All equipment required to remove and
reinstall each module is listed in the first step of its procedure.
Table 6Ć5: Tools required for module removal
Item
No.
Name Description
Tektronix part
number
1 Screwdriver handle Accepts PhillipsĆdriver bits
2 #1 Phillips tip PhillipsĆdriver bit for #1 size
screw heads
3 #2 Phillips tip PhillipsĆdriver bit for #2 size
screw heads
4 FlatĆbladed screwdriver Screwdriver for removing
standardĆheaded screws
5 Hex wrench, 0.05 inch Standard tool
6 Hex wrench,
1
/
16
inch Standard tool
7 OpenĆend wrench,
1
/
2
inch Standard tool
8 OpenĆend wrench,
5
/
16
inch Standard tool
9 Nut driver,
1
/
2
inch Standard tool
10 Nut driver,
1
/
4
inch Standard tool
11 Nut driver,
5
/
16
inch Standard tool
12 Nut driver, 5 mm Standard tool
13 AngleĆtip tweezers Standard tool
14 NeedleĆnose pliers Standard tool