Filter
Top Products
7 - 1
MELSEC-Q
7. SYSTEM CHECKING FROM PERIPHERAL DEVICE
7
7. SYSTEM CHECKING FROM PERIPHERAL DEVICE
Specify the QD75 to be accessed per project, also check connections with the external
equipment (servo amplifiers, servo motors, etc.), and conduct initial operation tests of
the servo motors.
7.1 Connection Setup
PURPOSE
Choose the interface connected to the QCPU or Q corresponding serial
communication module, and set the I/O address, etc. of the QD75 to be accessed.
BASIC OPERATION
1. Click the [Online]
[Connection setup] menu.
2. Choose the interface in the Connection setup dialog box and set the I/O
address, etc.
3. After the setting is completed, click the "OK" button.
DISPLAY/SETTING SCREEN
DISPLAY/SETTING DATA
Item Description
(Personal computer side)
Interface
Choose the type of the personal computer side interface.
The selection range is RS232C or USB.
(This is fixed to RS-232C if C24 connection or remote I/O was selected as the PLC side
interface.)
COM
Choose the COM port if the personal computer side interface is RS-232C.
The selection range is COM1 to COM10.
Baud rate
Choose the baud rate if the personal computer side interface is RS-232C.
The selection range is 9.6kbps to 115.2kbps.