Filter
Top Products
10 - 28
MELSEC-Q
10. POSITIONING DEBUGGING
10.4.4 OPR test
PURPOSE
Perform an OPR test to set up an original point and correct the preset OPR basic
parameters and OPR extended parameters.
BASIC OPERATION
1. Place the QD75 in the test mode in accordance with Section 10.4 (1).
2. Click the [Online]
[Test] [Operation test] [Operation test #1 to #4] menu (
to
).
3. Click the <<OPR>> tab in the TEST MODE setting dialog box.
4. Check the OPR method, OPR speed and Original point address.
5. Choose the OPR type and click the "REQ. OPR" button.
6. To exit, click the "Close" button.
DISPLAY/SETTING SCREEN