Filter
Top Products
4 - 11
MELSEC-Q
4. INSTALLATION AND UNINSTALLATION
4.4 Exiting SW D5C-QD75P-E
This section describes how to exit SW
D5C-QD75P-E.
(1) Menu-driven exit method
Click the [Project]
[Exit] menu.
SW
D5C-QD75P-E ends.
(2) Title bar-driven exit method
Click and choose [Close].
Alternatively, click
at the right end of the title bar.
• In the online status such as the monitor or test mode, you cannot exit SW D5C-
QD75P-E.
In any of the following cases, end the program after choosing the offline status.
Monitor mode (refer to Section 10.2)
Test mode (refer to Section 10.4)
Online status for checking connect (refer to Section 7.4)
REMARK
When a new project has been created or a project has been modified but is not yet
saved, the confirmation dialog box appears to ask you whether you will save that
project or not.
When you do not want to save it, click the "No" button.
When you want to save it, click the "Yes" button.
When you save a new project, choose [Save as Project].
For further information, refer to Section 6.1.