Filter
Top Products
6 - 1
MELSEC-Q
6. PROJECT CREATION
6
6. PROJECT CREATION
A project is a collection of parameters, positioning data and block start data.
<SW
D5C-QD75P-E project makeup>
Project
Parameters (Axis #1 to #4)
There are basic parameters 1, basic parameters 2, extended parameters 1,
extended parameters 2, OPR basic parameters and OPR extended parameters.
Positioning data (Axis #1 to #4)
Data used to set the control data such as positioning control method and addresses.
Data No. 1 to 600 can be set for each axis.
Block start data (Axis #1 to #4)
Data used to attach a condition to a positioning control start and set the repeat count.
Note: Equivalent to the start block data of the AD75 positioning module.
• When executing "New Project" or "Save as Project", you cannot set a space and
period in the project name to be specified. Further, you cannot set the following
characters and symbols.
/ , : ; * " < > | \\ COM LPT AUX CON PRN NUL CLOCK$
• You cannot set the following characters and symbols in a project path.
/ , : ; * " < > | \\ COM LPT AUX CON PRN NUL CLOCK$