Mitsubishi Electronics SW0D5C-QD75P-E Weather Radio User Manual


 
11 - 1
MELSEC-Q
11. USEFUL FUNCTIONS
11
11. USEFUL FUNCTIONS
Out of the functions that can be performed on SW D5C-QD75P-E, this chapter
describes the functions and operations useful for project execution, positioning data
setting, etc. and the functions which support settings.
This chapter also explains the teaching function which imports the feed present value
to the address, the function which writes positioning data in the test mode, the function
which prints project setting data, and the trace function which displays operation
results as waveform/locus data.
11.1 Useful Functions for Projects
This section describes the functions and operations which are helpful for utilizing
project data to create projects and for changing set data.
11.1.1 Verifying the project data
PURPOSE
Compare and verify the parameters, positioning data, block start data and
condition data of the project set as the active project and the saved project.
BASIC OPERATION
1. Set the verify source project as the active project. (Refer to Section 5.2.)
2. Click the [Project]
[Verify Project] menu (
).
3. Choose the verify target project in the Verify project dialog box (1) and click the
"Verify" button.
4. Set the types and ranges of the data to be verified in the Verify project dialog
box (2).
5. Click the "OK" button.
6. Check the results in the Verify result dialog box.
DISPLAY/SETTING SCREEN
[Verify project dialog box (1)]