Filter
Top Products
6 ErrorMessages
-399 to -300: Device-Specific Errors ESG Family Signal Generators
-399 to -300: Device-Specific Errors
Some device operations did not properly complete, possibly due to an abnormal hardware
or firmware condition. These codes are also used for self-test response errors. Errors in this
class set the device-specific error bit (bit 3) in the event status register (IEEE 488.2,
section 11.5.1).
-362 Framing error in program message
A stop bit was not detected when data was received (for example, a baud
rate mismatch).
-361 Parity error in program message
The parity bit was not correct when data was received (for example, an
incorrect parity bit on a serial port).
-360 Communication error
This is the generic communication error for devices that cannot detect the
more specific errors described for errors -361 and -362.
-350 Queue overflow
This is a specific code entered into the queue in lieu of the code that caused
the error. This message indicates that there is no more room in the queue
and an error occurred but was not recorded.
-340 Calibration failed
The device has detected a failure during its calibration procedure.
-330 Self-test failed
The device has detected a failure during its self-test procedure.
Self-test failed; Bad address position @ 0x____
The data generator memory failed. Modulation data produced by the data
generator may not be correct. An address that appeared to have a failed
address line was reported. Report this error to the nearest
Agilent Technologies sales or service office.