Filter
Top Products
42 ErrorMessages
-299 to -200: Execution Errors ESG Family Signal Generators
Settings conflict; RDCCH is only defined for Radio
Configuration 3 and 4. You must set one of these Radio
Configurations before configuring or using this code channel.
An attempt was made to setup the R-DCCH while in a radio configuration
that does not support this channel. This channel is only available in RC3
and RC4. If the R-DCCH is the desired channel, you must change to the
proper radio configuration before continuing.
Settings conflict; REACH is only defined for Radio
Configuration 3 and 4. You must set one of these Radio
Configurations before configuring or using this code channel.
An attempt was made to setup the R-EACH while in a radio configuration
that does not support this channel. This channel is only available in RC3
and RC4. If the R-EACH is the desired channel, you must change to the
proper radio configuration before continuing.
Settings conflict; The requested operation is not allowed in a
two box CDMA2000 setup.
Certain operations, such as setting to equal powers, are not allowed in a
two-ESG setup. A two-ESG setup exists when either Voltage Other ESG or
Percent Power Other ESG are greater than 0.0.
Settings conflict; RPICH is only defined for Radio
Configuration 3 and 4. You must set one of these Radio
Configurations before configuring or using this code channel.
An attempt was made to setup the R-PICH while in a radio configuration
that does not support this channel. This channel is only available in RC3
and RC4. If the R-PICH is the desired channel, you must change to the
proper radio configuration before continuing.
Settings conflict; RSCH with Turbo coding is only available in
Radio Configurations 3 and 4. You must set one of these Radio
Configurations to proceed.
Turbo coding is only allowed with the R-SCH in RC3 and 4. If turbo coding
is needed, change to the appropriate radio configuration, set up the proper
channels in addition to the R-SCH, and turn on turbo coding.