Filter
Top Products
Error Messages 45
ESG Family Signal Generators -299 to -200: Execution Errors
Settings conflict; Walsh length invalid! Changed to default
Walsh number.
The current Walsh length is invalid for the current data rate. For data rate
2X and above, doubling the rate halves the Walsh space. The channel
Walsh number has been changed to the highest valid Walsh code.
Settings conflict; You may not set Forward Link values while
in Reverse Link. Reset Link Direction to proceed.
Values or settings for forward link were entered while in reverse link. If
forward link is the desired link direction, set the ESG to forward link first,
and then re-enter the values or settings. However, if reverse link is the
correct link direction, consult the Option 201 user’s and programming
guide for the correct values or settings to enter.
Settings conflict; You may not set Reverse Link values while
in Forward Link. Reset Link Direction to proceed.
Values or settings for reverse link were entered while in forward link. If
reverse link is the desired link direction, set the ESG to reverse link first,
and then re-enter the values or settings. However, if forward link is the
correct link direction, consult the Option 201 user’s and programming
guide for the correct values or settings to enter.
Settings conflict; You may only setup channels that are part
of your current radio configuration.
An attempt was made to enter a value or setting for a channel that is not
supported in the current radio configuration. The R-FCH and R-SCH are
supported in all the radio configurations for reverse link. However, the
values or settings allowed for these channels vary according to the radio
configuration used. Refer to the Option 201 user’s and programming guide
to determine the supported channels by radio configuration.