Filter
Top Products
Error Messages 33
ESG Family Signal Generators -299 to -200: Execution Errors
Settings conflict; Cannot have more than 4 EDGE multiframe
timeslots on simultaneously. The selected timeslot has been
turned off.
An unsupported timeslot type was encountered. EDGE does not support
the simultaneous activation of more than four multiframe timeslots.
Settings conflict; Cannot have uplink protocols while the
control frame is on. Frames 1-17 timeslots changed to
downlink.
Indicates that, in TETRA mode, some of the timeslots are set to uplink.
When the control frame is turned on in TETRA, all timeslots in all frames
must use downlink protocols. The instrument enforces this by
reconfiguring the timeslots that are not using downlink protocols when the
control frame is switched on.
Settings conflict; Cannot select uplink protocols while the
control frame is on. Selection changed to custom.
Indicates that in TETRA mode, an attempt has been made to select uplink
protocols while the control frame is switched on. TETRA requires that the
control frame be switched off in order to select uplink protocols.
Settings conflict; Carrier formats must be the same.
All digital modulation multicarriers must be the same format.
Settings conflict; Channel #<NUMBER> must be on for any
transport channel following it to be on. All transport
channels following channel #<NUMBER> have been turned off.
Transport channels must be turned on sequentially. Therefore, all
transport channels with a higher number than a channel that is turned off
will be automatically turned off.
Settings conflict; Channel #<NUMBER> must be turned on before
channel #<NUMBER> can be turned on. Channel #<NUMBER> has been
turned off.
Transport channels must be turned on sequentially. For example,
channels 1, 2, and 3 must be turned on before channels 4 through 6 can be
activated.