Filter
Top Products
Error Messages 69
ESG Family Signal Generators 201 to 702: Device-Specific Errors
State Save Recall Error; Recall data different from FW
revision. No instrument state change.
An attempt was made to recall a state that was saved with an
incompatible version of the instrument firmware. This typically occurs
when a state file is copied from an instrument with a newer version of
firmware to an instrument with an older version of firmware. Newer
versions of instrument firmware can read older state files.
State Save Recall Error; Recall non-saved state register.
Recall ignored.
A recall was attempted for a state register that is unused. If state file
exists, delete explicitly using catalog.
State Save Recall Error; Recalled state has a bad checksum. No
instrument state change.
The state file was corrupt or out-of-date, so the recall was ignored. If state
file exists, delete explicitly using the memory catalog.
State Save Recall Error; The state file is from a different
firmware revision that does not support comments.
An attempt was made to write a comment to a state file revision that does
not support comments. Comments in saved state files are not supported by
the A.01.00 and A.01.01 releases of the instrument firmware.
State Save Recall Error; Unable to read the secondary frame
instrument state file. The secondary frame has been turned
off.
The format that is currently active needed the secondary frame
instrument state file to generate the secondary frame in pattern RAM, but
the instrument state file was either not previously saved or it was deleted.
You must create and save a secondary frame instrument state.
702 Load/Store Error; Cannot create a filter with no coefficients.
A filter must have at least one coefficient specified.
Load/Store Error; Cannot create a Modulation with less than
one bit per symbol.
A modulation must have at least two states specified.