Filter
Top Products
14 ErrorMessages
-399 to -300: Device-Specific Errors ESG Family Signal Generators
Configuration memory lost; Persistent state checksum is bad.
Using factory defaults.
The persistent state is corrupt and had to be reinitialized with the factory
preset values.
Configuration memory lost; Persistent state preset. Using
factory defaults.
The persistent state has been forced to return to factory preset values.
Configuration memory lost; Persistent state version is bad.
Using factory defaults.
The persistent state version is not recognized as valid and is assumed to
be corrupt. The persistent state is reinitialized with the factory preset
values.
-314 Save/recall memory loss
The non-volatile data saved by the *SAV? command has been lost.
-313 Calibration memory lost
Indicates that non-volatile calibration data has been lost.
-312 PUD memory lost
The protected user data saved by the *PUD command has been lost.
-311 Memory error
An error was detected in the device’s memory.
Memory error; Unable to configure Save Recall registers from
non-volatile memory. Save Recall registers re-initialized.
Indicates that saved states are no longer usable. Delete explicitly using
Catalog.
-310 System error; Absolute I and Q voltages must be at most
1 volt.
An internal error has occurred that results in the normalized I or Q
voltage to be greater than 1 volt. Report this error to the nearest
Agilent Technologies sales or service office.