Filter
Top Products
Error Messages 25
ESG Family Signal Generators -299 to -200: Execution Errors
Data corrupt or stale; <filename>.
The sequence file that you are attempting to run is the wrong size.
Data corrupt or stale; <NAME> differs offset 0x<VALUE>: NVRAM
0x<VALUE>, EEPROM 0x<VALUE>.
This message can occur only if full power-on EEPROM comparison mode is
set by the factory. If this mode is set, this message indicates that the data
that was retained by the EEPROM did not match the shadow data that
was retained by the shadow non-volatile RAM, even though no
uncorrectable errors or CRC mismatch was found in the shadow memory.
This error usually indicates that the instrument lost power during
EEPROM programming. If the instrument was quiescent when it was
powered off, report this error to the nearest Agilent Technologies sales or
service office.
Data corrupt or stale; EEPROM @ offset 0x<VALUE>: wrote
0x<VALUE>, read 0x<VALUE>.
After writing shadow RAM data to EEPROM, a memory comparison
detected a difference. The EEPROM may not be retaining data properly.
Report this error to the nearest Agilent Technologies sales or service office.
Data corrupt or stale; EEPROM copy of <filename>.
The EEPROM copy of a file is either corrupt or otherwise unusable. The
system automatically updates the non-volatile RAM copy of the EEPROM
copy using a default initialization. The actual EEPROM file is left as it is.
Report this error to the nearest Agilent Technologies sales or service office.
Data corrupt or stale; Either the file is not a bit file, or
the number of bits specified does not match with the number of
data bytes in the file.
An error has occurred while downloading a user file to the Bit memory
catalog. Either the user file is not a bit file, or the number of bits specified
in the SCPI command does not match the number of bytes in the file.
Ensure that the bit specifier matches the actual number of bits in the file.
Data corrupt or stale; file @ offset 0x<VALUE>: wrote
0x<VALUE>, retained 0x<VALUE>.
After writing shadow RAM data to EEPROM, a memory comparison
detected a difference. The EEPROM may not be retaining data properly.
Report this error to the nearest Agilent Technologies sales or service office.