Filter
Top Products
Error Messages 41
ESG Family Signal Generators -299 to -200: Execution Errors
Settings conflict; Pulse modulation cannot be on with internal
burst.
There is a hardware conflict between pulse modulation and internal burst.
The most recently requested modulation is turned on, the previous
modulation is turned off.
Settings conflict; Pulse period set less than pulse width.
Pulse width changed to match period value.
A pulse period has been entered that is smaller than the pulse width. The
instrument automatically adjusts the pulse period to match the pulse
width.
Settings conflict; The puncture rate is >=100% on DCH channel
<NUMBER>, increase the DPCH Slot Format or edit the DCH fields
to reduce the puncture %. All DPCH channels were turned off.
Transport channels cannot be punctured more than 100%. The slot format
needs to be increased (which in turn increased the symbol rate) on the
underlying DPCH channel, or the transport channel parameters must be
changed to reduce the puncture percentage. The underlying DPCH
channel has been turned off.
Settings conflict; QPCH and FFCH/OCNS cannot be on at the same
time. FFCH/OCNS has been tuned off.
QPCH is generated using both channel 3 and 4. Channel 4 is now used to
generate QPCH. Channel 3 can no longer generate FFCH/OCNS therefore,
FFCH/OCNS must be turned off.
Settings conflict; RACH is only defined for Radio
Configuration 1 and 2. You must set one of these Radio
Configurations before configuring or using this code channel.
An attempt was made to setup the R-ACH while in a radio configuration
that does not support this channel. This channel is only available in RC1
and RC2. If the R-ACH is the desired channel, you must change to the
proper radio configuration before continuing.
Settings conflict; RCCCH is only defined for Radio
Configuration 3 and 4. You must set one of these Radio
Configurations before configuring or using this code channel.
An attempt was made to setup the R-CCCH while in a radio configuration
that does not support this channel. This channel is only available in RC3
and RC4. If the R-CCCH is the desired channel, you must change to the
proper radio configuration before continuing.