Filter
Top Products
68 ErrorMessages
201 to 702: Device-Specific Errors ESG Family Signal Generators
621 FPGA download failed; Demodulator board.
The download of the field programmable gate array code to the
Demodulator board failed.
FPGA download failed; Opt UN7.
The download of the field programmable gate array code to the RAM on
the A6 bit error rate tester board failed. Report this error to the nearest
Agilent Technologies sales or service office.
622 Sequence references self; <Sequence Name>.
The specified sequence is not allowed because it contains a reference to
itself.
623 Out of Lock; Demodulator VCO
The A/D 26 MHz clock is not correct. The problem may be with either the
10 MHz reference, or the 13 MHz GSM clock.
Out of Lock; Downconverter LO
There is a problem with the downconverter. The problem may be with
either the 10 MHz reference, or the 13 MHz GSM clock.
700 State Save Recall Error; Delete empty sequence
<sequence_name>. Delete sequence ignored.
You have attempted to delete a sequence that is empty (all registers
unused). This message is informational only. Typically this error is
reported several times when the “Delete All Sequences” command is
executed. If the file is displayed by catalog, delete explicitly.
State Save Recall Error; Delete sequence <sequence_name>
ignored.
A STATE: file in a sequence that is being deleted could not be deleted due
to the file not being found, data corruption, etc. If state file exists, delete
explicitly using the memory catalog.
State Save Recall Error; Recall aborted. Unable to recall the
state from non-volatile memory.
The state file was not readable, so the recall was aborted. If state file
exists, delete explicitly using the memory catalog.