Filter
Top Products
Error Messages 53
ESG Family Signal Generators -199 to -100: Command Errors
-110 Command header error
An error was detected in the header. This message is used when the device
cannot detect the more specific errors described for errors -111 through
-119.
-109 Missing parameter
Fewer parameters were received than required for the header. For
example, the *ESE common command requires one parameter, so receiving
*ESE is not allowed.
-108 Parameter not allowed
More parameters were received than expected for the header. For example,
the *ESE common command only accepts one parameter, so receiving
*ESE 0,1 is not allowed.
-105 GET not allowed
A Group Execute Trigger was received within a program message (see
IEEE 488.2, 7.7). Correct the GPIB controller program so that the GET
does not occur within a line of GPIB program code.
-104 Data type error
The parser recognized a data element that is not allowed. For example,
numeric or string data was expected, but block data was encountered.
-103 Invalid separator
The parser was expecting a separator and encountered an illegal
character. For example, the semicolon was omitted after a program
message unit.
-102 Syntax error; Bad compatibility language character
<character>.
In 8656/57 compatibility mode, illegal language input was received.
Syntax error; Bad compatibility language token <token>.
In 8656/57 compatibility mode, a known command or termination specifier
was received when it was not expected. For example, a termination
specifier was received with no currently active function.