Filter
Top Products
Error Messages 47
ESG Family Signal Generators -299 to -200: Execution Errors
Init ignored; Unable to sweep due to sweep being in an error
state. The sweep error should be fixed.
The number of list, power, and/or dwell points are in conflict, or a serious
system error has occurred in list/sweep. A previous error report should
have described the error that is stalling list/sweep.
-212 Arm ignored
An arming signal was received and recognized by the device but was
ignored.
-211 Trigger ignored
A GET, *TRG, or triggering signal was received and recognized by the
device, but was ignored because of device timing considerations. For
example, the device was not ready to respond.
-210 Trigger error
A GET,*TRG, or a triggering signal could not be executed due to an error.
-202 Settings lost due to rtl
A setting associated with a hard local control (see IEEE 488.2, 5.6.15) was
lost when the device changed to LOCS from REMS or to LWLS from
RWLS.
-201 Invalid while in local
A command is not executable while the device is in local mode due to a
hard local control (see IEEE 488.2, 5.6.1.5). For example, a device with a
rotary switch receives a message which would change the switch’s state,
but the device is in local so the message cannot be executed.
-200 Execution Error
For devices that cannot detect more specific errors, this code indicates only
that an execution error as defined in IEEE 488.2, 11.5.1.1.5 has occurred.
Execution Error; Cannot transmit paging message to FlexDG.
There is an error with the cdma2000 hardware. Try turning CDMA2000
mode off and on again to reset the card. If the problem persists, report this
error to the nearest Agilent Technologies sales or service office.