Filter
Top Products
30 ErrorMessages
-299 to -200: Execution Errors ESG Family Signal Generators
Data out of range; Manual point exceeds list sizes. Limiting
to maximum point.
The sweep/list manual point has been reassigned to a smaller number
value due to the longest list decreasing in size or being turned off. Its new
value is the length of the longest enabled list (frequency or power).
Data out of range; Manual point exceeds frequency list size.
Limiting to maximum point.
The sweep/list manual point has been reassigned to a smaller number
value due to the longest list decreasing in size or being turned off. Its new
value is the length of the frequency list that is the longest enabled list.
Data out of range; Manual point exceeds power list size.
Limiting to maximum point.
The sweep/list manual point has been reassigned to a smaller number
value due to the longest list shrinking, or being turned off. Its new value is
the length of the power list, that is the longest enabled list.
Data out of range; Only DEFAULT or USER FILE data type is
allowed. Data type is changed to DEFAULT
Only Default data or user file is valid for Paging channel. Paging data is
now set to default.
Data out of range; The specified filter has too many symbols.
The baseband cannot function.
The filter is in a state that is inappropriate for the hardware. Although no
damage to the hardware will occur, the output is in an unknown state.
Report this error to the nearest Agilent Technologies sales or service office.
Data out of range; Synthesizer: Frequency out of bounds.
The signal generator received an internal request for a frequency outside
of its supported frequency range. Report this error to the nearest Agilent
Technologies sales or service office.
Data out of range; value clipped to lower limit.
An input value is below the minimum value allowed. Examples are:
frequency setting, reference, or offset; output power; power reference and
offset; modulation depth, deviation, or modulation source frequency;
number of points and start/stop values for list mode; start/stop values for
internal I/Q calibration; sequence or register values (save/recall); dwell
time.