Filter
Top Products
Creating Motions 119
FXDeko User’s Guide
PLAYING A MOTION
The Motion Editor provides tools for specifying playback rate and playing the
motions in the current .mot file.
To specify the playback rate of motions in the
current .mot file:
1. Enter a numerical value in the Playback rate box on the Motion
Editor toolbar.
2. Click the arrow to the right of the Units of playback rate box and
select seconds or frames.
To specify in/out times for a motion descriptor:
1. Click and hold either end of an offset bar to view the current in or
out time for the corresponding descriptor.
2. Drag the offset bar to change in and out times equally, or drag only
one end of the offset bar right or left to adjust the in or out time.
3. Drag the offset bar to change in and out times equally, or drag only
one end of the offset bar right or left to adjust the in or out time.
Note
You can select multiple offset bars, by holding Ctrl and
clicking the end of each bar, and adjust them as a group.
To specify a pause:
Click the pause button just below the offset bar for the motion
descriptor. During playback, FXDeko will pause the motion at the
specified in time. Click play to resume playback. Note that if you
use a Cap shader with the Continuous option selected, Deko
automatically pauses the end of the motion.