Filter
Top Products
7
Place the remaining expander boards on top of the master board.
Feed the 2x25 cables that are plugged into the master card through
the cable access holes of the expander cards. Plug the 2x25 cables
into J9 and J10 of the expander cards.
8
Feed the free end of the 2x10 cables of the expander cards through
the access holes to the master card. Plug the 2x10 cables into J7
(expander that is next to the master card) and J8 (top-most expander
in a four- or five-card configuration) on the master card.
Installation
To configure a multi-card module
14–6