Filter
Top Products
Two pod pairs are needed to use both timers.
If both timers are being
used in a single chip analyzer, and there are no spare chips, this message is
shown when Run is selected. Timer2 references in the sequencer will not be
valid.
No active analyzer.
This message is displayed if Run is selected with no
analyzers turned on.
Cannot read unrecognized data.
The user is trying to translate a SPA
configuration from a foreign module.
Demultiplexed clocking cannot be translated.
The user is trying to
translate a configuration that has demultiplexed or mixed clocks.
User thresholds have been truncated.
The user is trying to translate a
configuration having thresholds greater than 6 Volts or less than -6 Volts.
Slave clocks may need manual adjustment.
The user is trying to
translate an HP 16540/41A,D configuration which has slave clocks specified.
This message appears when the translation is not direct.
Clock Qualifiers not fully restored.
The user is trying to translate a
configuration that has more than two qualifiers.
No state machines for this module.
The user is trying to load an inverse
assembler into a module with no state machines.
Error loading DISPLAY1.
User is loading a configuration with a corrupt
DISPLAY1 section.
Pods have been truncated.
User is loading a configuration with number of
chips greater than the current system’s number of chips.
Clock pod and least significant pods have been preserved.
User is
loading a configuration with number of chips greater than the current
system’s number of chips
Need to have two free sequence levels.
For each sequence level with a
"<" assigned, you must leave two sequence levels free. To free up two levels,
simply delete two levels.
Mixed Mode not available.
User is trying to show mixed mode incorrectly.
Incompatible data not loaded.
User is loading data originally saved on
another model of 110/500 MHz Logic Analyzer. Saved data from one model
cannot be read by the other models.
Error Messages
Warning Messages
12–5