Filter
Top Products
Warning Messages
Waiting for Prestore.
This message is displayed for a timing analyzer
waiting for prestore.
Search failed - X pattern not found.
The X pattern specified could not be
found; therefore, the pattern marker could not be placed in the data.
Search failed - O pattern not found.
The O pattern specified could not
be found, therefore the pattern marker could not be placed in the data.
Warning: Run HALTED due to variable change.
This message appears
when certain analyzer settings are changed during a repetitive run. When
this occurs, the analyzer stops.
Error not found.
The Find Error number specified could not be found.
s/Div set to limit.
The s/Div field is set to its limit. The s/Division limit is
inversely proportional to maximum memory length.
Delay set to limit.
The Delay field is set to its limit. This limit is the
absolute value of the memory length.
Machine name: "filename" inverse assembler not found.
This message
appears when the inverse assembler file could not be found.
Slow or missing clock.
This message indicates a slow or missing clock.
This is displayed for a state analyzer only until the first clock occurs.
Data was acquired without time tags.
Time tag values will not be
displayed because data was stored without time tags. If you want time tags
stamped on the data, set Count in the Trigger menu to Time.
Data was acquired without state tags.
State tag values will not be
displayed because data was stored without state tags. If you want state tags
stamped on the data, set Count in the Trigger menu to State.
Error Messages
Warning Messages
12–4