Filter
Top Products
PPG System Commands
164 PT Program Generator (PPG) v5.0
Using Predefined Defaults
The PSC Falcon PT40 use the following four sets of parameter defaults. Reset
the portable to a predefined default set by scanning one of the bar codes in
Table 3 on page 164.
Table 3. Predefined Defaults for the PT40
Predefined Defaults
Default Name Bar Code Description
Predefined
Default 0
(D0)
Turns every ON/OFF param-
eter
OFF and sets all mini-
mum and maximum lengths
to zero.
Predefined
Default 1
(D1)
Turns every ON/OFF param-
eter
ON, sets all minimum
lengths as low as possible,
and sets all maximum lengths
as high as possible.
Predefined
Default 2
(D2)
Default set installed on the
portable at the factory. This
default set will work for most
applications.
Serial Default
Restores the default serial
communications settings.
*$+$-D0EE*
*$+$-D1EE*
*$+$-D2EE*
*$+$-C8EE*