Filter
Top Products
PT40 Communication
94 PT Program Generator (PPG) v5.0
Transfer Tab
Select the Transfer tab to establish file transfer settings.
Protocol
Select either XModem or ACK/NAK as the
file transfer
Protocol for sending and receiv-
ing files.
NOTE: The PT40 defaults to the
ACK/NAK protocol unless you
select
XModem. XFER32 defaults to the ZModem Protocol.
ACK/NAK and XModem protocol are the only two protocols sup-
ported by the PT40.
NOTE:
ZModem Protocol is NOT supported by the PT40.
Maximum Errors Enter the maximum number of
Errors permitted before a file transfer
is aborted. Range:
1 to 50. 0 specifies no limit to the number of file
transfer errors.
Flow Control
Select the mechanism used to control the flow
of data. Sender and receiver must agree on the
flow control method.
Note:
RTS/CTS is the default. Use either None or RTS/CTS.
XON/XOFF is not supported by the Falcon PT40.
None No flow control used.
XON/XOFF
NOTE:
ZModem Protocol is NOT supported by the Falcon PT40.
This feature is only available with ZModem protocol.
RTS/CTS Hardware flow control that uses
Request to Send (RTS), and Clear
to Send
(CTS) serial port lines to communicate when to suspend and
resume data transfer.
Window Size
NOTE:
ZModem Protocol is NOT supported by the Falcon PT40.
This feature is only available with ZModem protocol.
Crash Recovery
NOTE:
ZModem Protocol is NOT supported by the Falcon PT40.
This feature is only available with
ZModem protocol.
2342.book Page 94 Thursday, July 22, 2004 8:35 AM