Filter
Top Products
6 Line, Tunnel, Terminal, and Host Settings
XPort Pro™ User Guide 52
Terminal on Line
Configuration Page
Settings
Description
Terminal Type
Enter text to describe the type of terminal. The text will
be sent to a host via IAC.
Note: IAC means, “interpret as command.” It is a way
to send commands over the network such as send
break or start echoing.
Login Connect
Menu
Select the interface to display when the user logs in.
Choices are:
Enabled = shows the Login Connect Menu.
Disabled = shows the CLI
Exit Connect Menu
Select whether to display a choice for the user to exit
the Login Connect Menu and reach the CLI. Choices
are:
Enabled = a choice allows the user to exit to the CLI.
Disabled = there is no exit to the CLI.
Send Break
Enter a Send Break control character, e.g., <control>
Y, or blank to disable.
When the Send Break control character is received
from the network on its way to the serial line, it is not
sent to the line; instead, the line output is forced to be
inactive (the break condition).
Break Duration
Enter how long the break should last in milliseconds.
Echo
Applies only to Connect Mode Telnet connections, not
to Accept Mode. Only disable Echo if your terminal
echoes, in which case you will see double of each
character typed.
3. To save changes, click Submit.
Network Terminal Configuration
To configure menu features applicable to CLI access via the network:
1. Click Terminal on the menu and then click Network at the top of the page.
Configuration is automatically selected. The Terminal on Network Configuration
page appears.