Filter
Top Products
6 Line, Tunnel, Terminal, and Host Settings
XPort Pro™ User Guide 49
Figure 6-13. Tunnel 1 Disconnect Mode
2. Enter or modify the following settings:
Tunnel – Disconnect
Mode Page Settings
Description
Stop Character
Enter the stop character in ASCII, hexadecimal, or
decimal notation. Select <None> to disable.
Modem Control Select Enabled to disconnect when the modem control
pin is not asserted on the serial line.
Timeout
Enter a time, in milliseconds, for the XPort Pro to
disconnect on a timeout. The value 0 (zero) disables the
idle timeout.
Flush Serial Data Select Enabled to flush the serial data buffer on a
disconnection.
3. Click Submit.
Modem Emulation
A tunnel in Connect Mode can be initiated using modem commands incoming from
the Serial Line. This page enables you to configure the modem emulation settings
when you select Modem Emulation as the Tunnel 1 or Tunnel 2 Connect Mode type.
To configure modem emulation:
1. Select Tunnel 1 and then Modem Emulation at the top of the page. The
Tunnel 1 Modem Emulation page appears.