Filter
Top Products
12 Advanced Settings
XPort Pro™ User Guide 114
CLI Configuration
On this page you can change CLI configuration settings.
To configure the CLI:
1. Click CLI on the menu and then Configuration at the top of the page. The
Command Line Interface Configuration page appears.
Figure 12-4. Command Line Interface Configuration
2. Enter or modify the following settings:
Command Line
Interface
Configuration
Settings
Description
Login Password
Enter the password for Telnet access.
Enable Level
Password
Enter the password for access to the Command
Mode Enable level. There is no password by default.
Quit connect line
Enter a string to terminate a connect line session and
resume the CLI. Type <control> before any key the
user must press when holding down the Ctrl key. An
example of such a string is <control>L.
Inactivity Timeout
Set an Inactivity Timeout value so the CLI session will
disconnect if no data is received after the designated
time period. Default is 15 minutes. Enter a value of 0
to disable.