Filter
Top Products
6 Line, Tunnel, Terminal, and Host Settings
XPort Pro™ User Guide 46
Tunnel –
Connect Mode
Page Settings
Description
Flush Serial Data
Select whether to flush the serial line when a connection
is made. Choices are:
Enabled = flush the serial line when a connection is
made.
Disabled = do not flush the serial line. (default)
Block Serial Data
Select On to block (not tunnel) serial data transmitted to
the XPort Pro.
Block Network
Data
Select On to block (not tunnel) network data transmitted
to the XPort Pro.
Email on
Connect
Select whether the XPort Pro sends an email when a
connection is made. Select None if you do not want to
send an email. Otherwise, select the Email profile to use.
Email on
Disconnect
Select whether the XPort Pro sends an email when a
connection is closed. Select None if you do not want to
send an email. Otherwise, select the Email profile to use.
CP Output
Identifies a CP or CP Group whose value should change
when a connection is established and when it is
dropped.
3. Click Submit.
Host 1 is configured. A second host appears underneath Host 1 since the XPort Pro
supports configuration of up to sixteen hosts.
Connecting Multiple Hosts
If more than one Host is configured, a Host Mode option appears. Host Mode
controls how multiple hosts will be used in Connect Mode.
The following selections are available:
Sequential – When it is time for the tunnel to connect it will start with Host 1 and
attempt each host in sequence until a connection is accomplished. Default
selection.
Simultaneous – When it is time for the tunnel to connect it will connect to all of
the hosts that accept a connection.
Configuring Additional Hosts
The Host fields contain the information necessary to connect to the specified host.
To configure Host 2:
1. Click <None> in the Host 2 field. Host 2 expands.