Filter
Top Products
6 Line, Tunnel, Terminal, and Host Settings
XPort Pro™ User Guide 37
Line –
Command Mode
Page Settings
Description
the value of the CP group must be matched to enable
Command Mode.
Disabled = turns off Command Mode.
Wait Time
Enter the wait time for the serial string during boot-up in
milliseconds.
Serial String
Enter the serial string characters. Select a string type.
Text = string of bytes that must be read on the Serial Line
during boot time to enable Command Mode. It may contain a
time element in x milliseconds, in the format {x}, to specify a
required delay.
Binary = string of characters representing byte values where
each hexadecimal byte value starts with \0x and each
decimal byte value starts with \.
Echo Serial
String
Select Yes to enable echoing of the serial string at boot-up.
CP Group
Enter the name and decimal value of the CP group.
Signon
Message
Enter the boot-up signon message. Select a string type.
Text = string of bytes sent on the serial line during boot time.
Binary = one or more byte values separated by commas.
Each byte value may be decimal or hexadecimal. Start
hexadecimal values with 0x.
Note: This string will be output on the serial port at boot,
regardless of whether command mode is enabled or not.
3. In the Current Configuration table, clear currently stored settings as necessary.
4. Click Submit.
Tunnel Settings
The Tunnel pages allow you to view current statistics and configure serial settings,
Connect Mode, Accept Mode, Disconnect Mode, Packing Mode, start and stop
characters, modem emulation, and AES keys.
Note: The following section describes the steps to view and configure Tunnel 1
settings; these steps also apply to Tunnel 2 menu options.