Filter
Top Products
232 Creating and administering plexes
Moving plexes
If the vxinfo command shows that the volume is unstartable (see “Listing
Unstartable Volumes” in the section “Recovery from Hardware Failure” in
the Veritas Volume Manager Troubleshooting Guide), set one of the plexes
to CLEAN using the following command:
# vxmend [-g diskgroup] fix clean plex
Start the volume using the following command:
# vxvol [-g diskgroup] start volume
Moving plexes
Moving a plex copies the data content from the original plex onto a new plex. To
move a plex, use the following command:
# vxplex [-g diskgroup] mv original_plex new_plex
For a move task to be successful, the following criteria must be met:
■ The old plex must be an active part of an active (ENABLED) volume.
■ The new plex must be at least the same size or larger than the old plex.
■ The new plex must not be associated with another volume.
The size of the plex has several implications:
■ If the new plex is smaller or more sparse than the original plex, an
incomplete copy is made of the data on the original plex. If an incomplete
copy is desired, use the -o force option to
vxplex.
■ If the new plex is longer or less sparse than the original plex, the data that
exists on the original plex is copied onto the new plex. Any area that is not
on the original plex, but is represented on the new plex, is filled from other
complete plexes associated with the same volume.
■ If the new plex is longer than the volume itself, then the remaining area of
the new plex above the size of the volume is not initialized and remains
unused.