Filter
Top Products
228 Creating and administering plexes
Displaying plex information
TEMPRMSD plex state
The TEMPRMSD plex state is used by vxassist when attaching new data
plexes to a volume. If the synchronization operation does not complete, the plex
and its subdisks are removed.
Plex condition flags
vxprint may also display one of the following condition flags in the STATE
field:
IOFAIL plex condition
The plex was detached as a result of an I/O failure detected during normal
volume I/O. The plex is out-of-date with respect to the volume, and in need of
complete recovery. However, this condition also indicates a likelihood that one
of the disks in the system should be replaced.
NODAREC plex condition
No physical disk was found for one of the subdisks in the plex. This implies
either that the physical disk failed, making it unrecognizable, or that the
physical disk is no longer attached through a known access path. The plex
cannot be used until this condition is fixed, or the affected subdisk is
dissociated.
NODEVICE plex condition
A physical device could not be found corresponding to the disk ID in the disk
media record for one of the subdisks associated with the plex. The plex cannot
be used until this condition is fixed, or the affected subdisk is dissociated.
RECOVER plex condition
A disk corresponding to one of the disk media records was replaced, or was
reattached too late to prevent the plex from becoming out-of-date with respect
to the volume. The plex required complete recovery from another plex in the
volume to synchronize its contents.
REMOVED plex condition
Set in the disk media record when one of the subdisks associated with the plex is
removed. The plex cannot be used until this condition is fixed, or the affected
subdisk is dissociated.