Yamaha MU128 Portable Generator User Manual


 
90
MU128 Guided Tour
Applying Distortion to a Part —
Using the Variation Effects
The Variation effect section provides a wealth of additional effects. With a total
of 70 different Types, it features some of the same effects found in the Reverb,
Chorus and Insertion sections. This is not mere redundancy; it allows you to use
two Types of Reverb or Chorus on different Voices. For example, you may want
to have a Symphonic effect on one Voice and Phaser on another. Variation also
gives you many special effects not found in the Reverb and Chorus sections,
such as Delay, Gate Reverb, Wah and Pitch Change.
The Variation effect can be applied either to all Parts (as with Reverb and
Chorus), or to a single selected Part (as described below).
Operation
1 Set Variation Connection to “INS” (Insertion).
To use Variation with a single Part, the Variation Connection pa-
rameter should be set to Insertion.
To do this:
1) Press the [EFFECT] button.
2) Select “VAR” (with the [SELECT </>] buttons) and press
[ENTER].
3) Select “VarConnect” (with the [SELECT >] button), and
change the setting to “INS” (with the [VALUE -/+] but-
tons or data dial).
2 Select the desired Part and set its Variation Send control to “on.”
To do this:
1) Return to the Multi Play mode Single Part display (press
the [PLAY] button), then select the desired Part (with the
[PART -/+] buttons).
2) Select “VarSend” (with the [SELECT </>] buttons), and
set it to “on” (with the [VALUE-/+] buttons or data dial).
3 Return to the Variation parameters, select the Distortion Type,
and make other necessary settings.
To do this:
1) Press the [EFFECT] button.
2) Select “VAR” (with the [SELECT -/+] buttons) and press
[ENTER].
3) Select “Type” (with the [SELECT <] button), and change
the setting to “DISTORTION” (with the [VALUE -/+]
buttons or data dial).
Effects