Filter
Top Products
84
MU128 Guided Tour
4 Try the setting on other Voices.
Exit to the Multi Play mode display (press the [PLAY] button) and
select other Voices, trying out the new setting, and moving the
foot controller up and down as you play. Try out some of these
Voices, and notice how the sound changes:
SynBass2 (040), Saw Ld (082), Warm Pad (090) — for a
“wah” filter sweep effect.
SynVoice (055), NewAgePd (089) — for gradually fading in a
breathy sound.
For details on the AC1 Filter Control parameter, see page 124.
Details
Keep in mind that the degree and character of the AC1 Filter Control depends also
on the Filter parameter settings for the Part (see page 111). Some Voices may not
change at all unless these parameters are set appropriately. However, all of the
example Voices above should clearly change in response to AC1 (if the Filter pa-
rameters are all at their default setting of 00).
Resetting the parameter values
The simple operation below lets you instantly restore the factory preset values.
Since it automatically cancels any edits you’ve made, you should use it with
care.
1. Press the [MODE] button.
2. Select a different mode, then re-select the original one.
For example, if you were editing in the XG mode, use the [SELECT </>]
buttons to move the cursor to “TG300B,” then back to “XG.”
Doing this automatically resets all Part settings to the factory-programmed con-
dition and cancels any edits you made in the Multi mode (including whatever
Voices you selected).
Assignable Controller (AC1)