Filter
Top Products
76
MU128 Guided Tour
; Change the Vibrato Rate, Depth, and Delay settings.
Select one of the Parts and set the Vibrato parameters as follows:
Rate: +15
Depth: +04
Delay: +15
This produces a delayed vibrato for Part 1; in other words, the
vibrato effect starts after the keys have been held for a while.
Notes played staccato have no vibrato.
a Exit back to the Single Part control display.
Press the [PLAY] button.
Setting Up a Keyboard Split
In the following steps, you’ll assign two different Parts to separate sections
of the keyboard.
Operation
1 Select Part 2 and select a new Voice for it: “NewAgePd” (089).
From the Single Part display, use [PART -/+] buttons to select
Part 2. Then select Voice 089 in the normal way. (Keep Part 1’s
Voice set to “HeavySyn,” 082, as set in step #4 of “Creating a
Two-Voice Layer” above.)
2 Change the Note Limit High setting for Part 1.
The Note Limit parameters determines the range of notes over
which the Part will sound. To set this:
1) In Edit menu select and call up the “PART” menu, then do
the same with the “OTHERS” menu.
2) Select Part 1.
3) Select and change the “NoteLimitH” setting to “B2.” (Leave
the “NoteLimitL” setting unchanged.)
3 Change the Note Limit Low setting for Part 2.
1) Select Part 2.
2) Select and change the “NoteLimitL” setting to “C3.” (Leave
the “NoteLimitH” setting unchanged.)
Playing notes below middle C on the keyboard plays the synth bass
sound, while notes above middle C play the “New Age” pad.
Hint
You may want to raise the octave setting of Part 1. To do this, exit to Single Part,
select Part 1, then use the [SELECT
>
] buttons to select the Note Shift control. For
a higher “HeavySyn” Voice, set this to “+00.”)
Editing in the Performance Mode