Filter
Top Products
154
MU128 Effect Edit Mode
About the Effect Connections — System and Insertion
When Variation is set to Insertion:
NOTES
• As with System above, the Parts to which Insertion 1, 2 are applied is determined by the Part parameter in the Insertion section (page 151). Also,
the Part to which Variation is applied is determined by the Variation Send control in the Single Part controls (pages 108, 128, 136).
• As with System above, the effects cannot be properly heard unless the Reverb Send and Chorus Send parameters in the Single Part controls
(pages 107, 127, 128, 135) and the Reverb Return and Chorus Return parameters in the All Part controls (pages 109, 133) are set to appropriate
values.
• The stereo position of the effects is controlled by the Reverb Pan and Chorus Pan parameters. (pages 147, 148.)
• You can set Reverb and Chorus to be routed in parallel or in serial, and you can determine the amount of Chorus that is sent to Reverb. This is
done with the Send Chorus to Reverb parameter (page 148). When this is set to 0, Reverb and Chorus are in parallel routing. Higher values for
each provide varying degrees of serial routing.
rev send
dry
cho send
rev send
dry
cho send
rev send
dry
cho send
insertion2 part
variation part
Part1
REVERB
reverb
pan
send chorus to reverb
Part64
DRY LINE
PAN
PAN
reverb
return
chorus
pan
chorus
return
OUT
Thick line indicates stereo signal.
EQ
insertion2 can be applied to
only one Part at a time
CHORUS
Varationcan be applied to
only one Part at a time
insertion1 part
insertion1 can be applied to
only one Part at a time
rev send
cho send
Part A1
Part A2
INS2
INS2
INS2
INS2
VAR
VAR
VAR
VAR
insertion2
on/off variation on/off
insertion2
on/off variation on/off
insertion2
on/off variation on/off
insertion2
on/off
insertion1
on/off
insertion1
on/off
insertion1
on/off
insertion1
on/off variation on/off
dry
INS1
INS1
INS1
INS1