Filter
Top Products
104
MU128 Multi Mode
Multi Mode
In the Multi mode, the MU128 performs as a multi-timbral tone generator
capable of playing up to 64 Parts simultaneously, over 64 MIDI channels.
Normally, the MU128 should be set to Multi mode when using it with a
sequencer and General MIDI song data. There are two Multi modes: XG
and TG300B. (For information on selecting these, see pages 43 and 170.)
Part Controls
Part Controls............................................................................... 104
Single Part Control .............................................................. 105
All Part Control ................................................................... 109
Multi Edit Mode .......................................................................... 111
Filter (FIL) ........................................................................... 111
Envelope Generator (EG) .................................................... 113
Equalizer (EQ)..................................................................... 116
Vibrato ............................................................................... 117
Others ................................................................................ 118
Drum Setup Controls .......................................................... 126
Part Controls
The Part controls in the Play mode give you tools for adjusting the basic
sound and settings for each Part. The MU128 lets you adjust the various
settings for each Part individually (Single Part control) or together (All Part
control). Each of these types is explained in greater detail below.
NOTE
When the Sound Module mode is changed (page170), all settings in each mode
will be initialized to their factory values. However, you can use the Dump Out
function to save your settings to a MIDI data storage device. (See page 162.)