Filter
Top Products
MU128 Multi Mode
127
English
Assignment ............................................................ 130
●
Alternate Group
Note On/Off .......................................................... 130
●
Receive Note On (RcvNoteOn)
●
Receive Note Off
The Drum Setup parameters are only available when the Part Mode has
been set to drumS1 — S4. (See page 120.)
Pitch Parameters
Multi Edit Mode
Pitch Coarse
Range: –64 — +63 (XG mode)
0 — 127 (TG300B mode)
This determines the coarse pitch setting
of the selected drum sound.
Pitch Fine
Range: –64 — +63
This determines the fine pitch setting of
the selected drum sound.
Velocity Pitch Sensitivity (VelPchSens)
Range: –16 — +16
This determines the degree to which pitch
changes of the selected drum sound respond
to velocity. In other words, you can control
how much the pitch of the sound changes
by how hard or soft you play the keys of a
connected keyboard. Positive values raise
the pitch and negative values lower the
pitch. A value of 00 results in no pitch
change, whatever velocity is received.
Level
Level
Range: 000 — 127
This determines the volume of the se-
lected drum sound.
Pan
Pan
Settings: Rnd (Random), L63 — C —
R63
This determines the stereo position of the
selected drum sound. A setting of “Rnd”
(Random) randomly assigns the drum to a
pan position. This is useful when you want
to have different drums sound from differ-
ent random parts of the stereo image.
Effect Send Parameters
Reverb Send (Rev Send)
Range: 000 — 127
This determines the level of the selected
drum sound that is sent to the Reverb ef-
fect. A value of 000 results in a completely
“dry” drum sound, no matter how much
Reverb is applied to the Drum Part.
NOTE
Keep in mind that the Reverb effect must be
properly enabled and set for this parameter to
work as intended. (See page 88.) Also, the pa-
rameters Reverb Send in Single Part control
(page 107) and Reverb Return in All Part con-
trol (page 109) must be set to appropriate val-
ues.