Filter
Top Products
Rev. B
ProCore 648Page 6 – 12Chassis
Traction Control Cable
Removal
1. Remove traction control cable from hydraulic pump
control (Fig. 10) and traction lever on handle and (Fig.
11).
2. Remove traction control cable from machine noting
routing of cable to aid in correct installation.
3. Disassemble traction control cable using Figure 9 as
a guide.
Installation
1. Assemble traction control cable using Figure 9 as a
guide. Tighten lock nuts (item 6) so that compression
spring (item 4) has a length from 6.750” to 6.880” (17.2
to 17.4 cm).
2. Route traction control cable from traction lever on
handle to pump control noting original routing.
3. After assembly, make sure that steering components
do not contact traction cable.
4. Check and adjust traction drive for neutral (see Op-
erator’s Manual).
1. Traction control cable
2. Jam nut
3. Spring retainer
4. Compression spring
5. Override rod
6. Lock nut
7. Ball joint (traction lever)
8. Ball joint (pump lever)
Figure 9
2
3
4
1
5
6
7
2
2
8
1
1. Pump control
2. Traction control cable
3. Cable ball joint
Figure 10
1
3
2
1. Traction lever 2. Cable ball joint
Figure 11
1
2