Filter
Top Products
ProCore 648 Page 6 – 9 Chassis
Removal (Fig. 3)
1. Park machine on a level surface, fully raise coring
head, stop engine and remove key from the ignition
switch. Secure coring head with service latch. Make
sure that parking brake is not engaged.
2. Remove six (6) washer head screws that secure low-
er handle cover to control handle. Remove lower handle
cover.
3. Loosen jam nut that secures parking brake cable to
underside of control handle.
4. Remove cotter pin and flat washer that retain brake
cable to brake lever. Slide brake cable from brake lever.
5. Remove brake cable from parking latch pivot on rear
cross tube of frame (Fig. 6):
A. Remove hairpin and clevis pin that secure park-
ing brake cable clevis to parking latch pivot.
B. Remove retaining ring that secures brake cable
to rear cross tube of frame.
6. Note routing of parking brake cable. Remove parking
brake cable from machine.
Installation (Fig. 3)
1. Position new parking brake cable to machine noting
original routing.
2. Secure brake cable to parking latch pivot on rear
cross tube of frame (Fig. 6):
A. Position parking brake cable clevis to parking
latch pivot and secure with clevis pin and hairpin.
B. Secure brake cable to rear cross tube of frame
with retaining ring.
3. Position brake cable end to parking brake lever. Se-
cure cable to lever with flat washer and cotter pin.
4. Secure parking brake cable to underside of control
handle with jam nuts.
5. Position lower handle cover to control handle and se-
cure with six (6) washer head screws.
6. Make sure that steering components do not contact
cables or wire harness.
7. Remove service latch from coring head before ma-
chine use.
1. Brake cable
2. Retaining ring
3. Hairpin
4. Clevis pin
5. Parking latch pivot
Figure 6
5
1
4
2
3
Chassis