Filter
Top Products
Printer Operations
Printing Measurement Data and Memory Card Directory
5
5-7
MOdE
ALL
ALAr
trAnS
Selecting the Destination Mode. The
destination mode determines when the printer
should print. Select trAns (Transition) to print
one complete scan when a channel has
transitioned into or out of an alarm limit. Select
ALAr (Alarm) to print all channel scans while any
channel is in an alarm condition (stopping when
all channels are out of alarm). Select ALL (All) to
print all scans. (See example printout below.)
dESt
both
Print
CArd
nonE
SHIFT
FILES
ENTER
Setting the DESTINATION Parameter. Press
the SHIFT key, release, then press the FILES
key to open the destination menu. Select both
(Both) to route measurement data to both the
memory card and printer; select Print (Printer) to
route measurement data just to the printer. After
selection, press ENTER.
Typical
Required
ENTER
18:29:57 07/21/94
0: 980.19 kOHMS 1: -023.85 VDC 3: 115.23 VAC H/H
9: 113.45 mVAC 12: 084.32 F L/ 18: 004.19 MX+B /H
ALM:7 DIO:175 TOTAL:0
Time
(Hours/Minutes/Seconds)
Alarm Status
(See Table 2-4)
Date
(Month/Day/Year)
Scanned Channels
(0, 1, 3, 9, 12, 18)
Digital I/0 Status
(See Table 2-5)
Totalizer Count
(See Figure 2-20)
Channel 12
(In Low Alarm)
Channel 18
(In High Alarm)
(Mx+B Scaled)
Channel 3
(In High/High Alarm)
op56f.eps
Figure 5-3. Printing Measurement Results During Scanning