Filter
Top Products
Programming Site Data 4-29
April 2004
Entering Skan/Integrate Parameters (cont.)
3. If you wish to use Measure Times only (instead of both Skan
and Measure times), press
[ENTER] at the Measure Only
prompt. (You can also press
[ENTER] to deselect the prompt.)
Pressing the [T] key returns the meter to the A Divisor entry, and
pressing the [
S] key returns the meter to the Integrate tab.
• To confirm the entries and return to Operate mode, press [F3]
(OK).
• To leave the window without confirming the entries and return
to Operate mode, press
[F2] (Cancel) or the [ESC] key.