Filter
Top Products
Logging Data 8-9
April 2004
Setting up a New Log (cont.)
Figure 8-7: The Select Measurement Window
2. Scroll to the desired output type.
3. Press
[SEL] to confirm your selection.
4. The prompt then moves to a list of unit types. (The available
units depend on the selection made at the Data Source
prompt.) Scroll to the desired output unit.
5. Press
[F3] (OK) to confirm your selection.
6. You can repeat this procedure for up to 12 different
parameters.
7. When you have finished, press
[F2] (Cancel) to cancel the
entries, or
[F3] (Activate) to confirm the entries and start the
log.
If you started the log from the New Log option, the PT878GC
returns to Operate Mode; if you started it from within the Log
Manager, the meter returns to the Log Manager.
Select Measurement
Cancell
OK
Diagnostics
Rev Totalizer
Volume
No Unit
Velocity
Fwd Totalizer
m/s
Pressure
Temperature
StdFwdTotalizer
StdRevTotalizer