Filter
Top Products
April 2004
4-52 Programming Site Data
Entering Reynolds Correction (cont.)
b. Enter the desired measurement and units as described on
page 4-40.
c. Press
[F3] (OK) to confirm your selection.
4. The prompt then asks if you wish to edit the Reynolds
Correction table.
a. Press
[ENTER] to open the table, which appears similar to
Figure 4-25 below.
Figure 4-25: Window for Reynolds Correction Table
b. Use the numeric keys to enter the first value for the data
source, and press
[ENTER] to confirm the entry.
c. Press the [
X] key to move to the Reynolds value column.
Use the numeric keys to enter the corresponding value, and
press
[ENTER] to confirm the entry.
d. Repeat steps b and c for the remainder of the table.
Inputs
Edit Reynolds Table
Cancell OK
0
Re
1
2
3
4
5
Data Source