Filter
Top Products
Programming Site Data 4-53
April 2004
Entering Reynolds Correction (cont.)
e. When you have completed entering values, press [F3] (OK)
to confirm the table and return to the Correction Factors
window.
You have completed entering data for a Reynolds Correction
table.
• To confirm the entries, press [F3] (OK). The meter returns to
Operate Mode.
• To leave the window without confirming the entries and return
to Operate mode, press
[F2] (Cancel) or the [ESC] key.
Entering a Calibration Factor
The Calibration Factor is used as a reference for the flowmeter
electronics to ensure accurate readings. To enter a Calibration
Factor, return to the Reynolds Correction tab at the top of the
Correction Factors option. Press the [X] arrow key to reach the
Calibration Factor window. The window appears similar to
Figure 4-26 below. To step through each parameter, press the [T]
key.
Figure 4-26: The Calibration Factor Window
Reynolds Correction Inputs
Correction Factors
Cancell OK
Calibration Factor
Edit Table
Calibration Factor
On
Off
Meter K-Factor
Data Source
K Factor
Single
Table
10
Edit Table