Filter
Top Products
Programming Site Data 4-55
April 2004
Entering a Calibration Factor (cont.)
b. Enter the desired measurement and units as described on
page 4-40.
c. Press
[F3] (OK) to confirm your selection.
4. The prompt then asks if you wish to edit the K factor table.
a. Press
[ENTER] to open the table, which appears similar to
Figure 4-27 below.
Figure 4-27: The KFactor Table
b. Use the numeric keys to enter the first value for the data
source, and press
[ENTER] to confirm the entry.
c. Press the [
X] key to move to the KFactor column. Use the
numeric keys to enter the corresponding value, and press
[ENTER] to confirm the entry.
d. Repeat steps b and c for the remainder of the table.
e. When you have completed entering values, press
[F3] (OK)
to confirm the table and return to the Correction Factors
window.
Inputs
Edit KFactor Table
Cancell OK
0
KFactor
1
2
3
4
5
Data Source